Mechanical-engg.com Website Review

the album contains best images required to have the perfect view for production engineering... why first angle and third angle projection method is used in machine design and why second and fourth angle method is not used? why first angle and third angle method is used and why second and fourth angle method is not used? on december 21, the new jiangling ford territory officially went off the line. feilong jiangli learned from the official that in mid-late january 2019, the new car will be officially announced the price, which is expected to range from 120,000 to 170,000 yuan. the new compact suv is located between wingbeat and wing tiger. for jiangling ford, a suv for pas*enger car market has been added, and the product line is more abundant. the whole system is equipped with a ford 1.5t in-cylinder direct injection engine with a maximum power of 140 horsepower and a maximum torque of 225 cows per meter. on this basis, a 48v light mixing system is also mounted on top of the vehicle, aiming at improving the power and fuel economy of the vehicle. 48v can not drive the vehicle alone. it has two main functions: one is engine power, the other is kinetic energy recovery. in the transmission system part, the new car will use cvt gearbox, low-matching model or matching 6mt gearbox. chongqing feilong jiangli has always been a supplier of jiangling ford's automotive parts, mainly supporting automotive water pumps and oil level gauges. oil level gauge has several specifications, such as 1.0l, 1.5l, 2.0l and 2.3l. the size, i am building a ground pushing and pulling probe similar to the pic attached.  a probe rod is hydraulically clamped and held in place using a split clamp jaws that have a pyramid grip pattern made from hardened tool steel 58hrc similar to the pics.  that particular cylinder to hold a similar load 200kn?  the clamp jaws will be approx. 150mm high and match the dia. of the probe pipe which is 36mm with a hardness of approximately 30-40hrc.  the clamp won't quite go the full diameter and will have a little gap at the ends.  the